How to make a medical mask

40 views

How to make a medical mask - Bird flu, SARS and other dangerous airborne virus scare people. Most people avoid getting sick by staying at home and not travel in crowded places. Although not the most pleasant aesthically, surgical masks will filter some airborne diseases. If you make medical masks at home, you retain the quality of the material without putting a hole in your wallet. polypropylene fiber is a material that is inexpensive and readily available. This is the same material used in many medical masks today.

How to make a medical mask

• Measure the distance of one inch on the left side of your mouth an inch from the right side of your mouth. This distance must be equal to the width of medical face mask.

• Measure the distance of two inches above your nose an inch below your mouth. This distance must be equal to the height of the medical mask.

• Place a ruler on the top edge of the polypropylene fiber. Mark the area on the polypropylene fiber of the same width you measured in step 1. This is the top of your mask.

• Place a ruler on the points of the line defined in step 3 on the top edge of the polypropylene fiber end. Draw vertical lines of the same height you measured in step 2. This is the side of your mask.

• Place a ruler perpendicular to the vertical line in step 4. Draw a horizontal line as wide as you measured in step 1. This is a rectangular shape.

• Cut the rectangular shape of the polypropylene fiber. Use it as the mask portion of your medical mask.

• puncture a hole in the upper and lower corners of the right side of the mask portion with a mechanical pencil. The elastic strip is placed in the holes. Make holes large enough for the elastic band to fit.

• punching a hole in the upper and lower corners of the left side of the mask portion with a mechanical pencil. The elastic strip is placed in the holes. Make holes large enough for the elastic band to fit.

• Put the mask on your face. Measure the distance between the side of your mask, around the back of your head to the other side of the mask using a tape measure.

How to make a medical mask

How to make a medical mask

• Cut two elastic bands in the measurement in Step 9 with scissors. The elastic bands must be well adjusted to avoid the mask fall.

• Attach one end of the elastic band to the upper right corner of the mask portion. Pull the rubber band to the top left corner of the mask portion. Push the elastic band from the rear side of the mask portion through the hole. Tie a knot to secure the elastic band in place.

• attach one end of the elastic band in the lower right corner of the mask portion. Pull the elastic band in the lower left corner of the mask portion. Push the elastic band from the rear side of the mask portion through the hole. Tie a knot to secure the elastic band in place. You are now ready to use your medical mask.

How to make a medical mask